So I'm in Oakland, CA until the 23rd of March. Wanted to see if anyone knew of shows that are happening out here. Let me know V13

Who does a Good Job & Reasonable Price on rebuilding Stromberg 97 Carbs - 3 x 2 setup for Ford Y-block ?

I'm using Evercoat z-grip. The hardener I got with it doesn't have any markings on it for a specific brand. Is this stuff universal? Can run out to wally world and get the hardener they sell for bondo brand for example? Thanks, Bill

Does anyone know where to find old episodes of this show on the cheap. I found it on Amazon but they are $9.95 plus shipping per episode and the episode i want is 3 parts. It isn't worth that much to me. If you guys know of a good place to find these please let me know. The T Coupe episodes...

Hey guys- Helped a buddy yank the original Timken rear end out of his '54 Willys pickup last weekend. Things went well until we got the pulling the yoke off the rear end - the castle nut holding it on won't budge. We used liberal amounts of penetrating oil, heat, and a decent amount of...

Shirl Greer ,1974 f/c champ is in the hosp in tn, in a coma. Brian Greer ,his youngest son, says he is going in surgery again today. This is all I know.

yes, i've spent three days in the search until i went crosseyed... what are the options for bagging the rear of my chevy without cutting the floors out? after seeing a couple of air over leaf arrangements and what it does to the springs, that option is off the table... i'm not trying to...

I've got a part in Kilgore Texas and the seller won't ship it. Is anyone close to there that I could pay to ship it to me?

I've been wanting a 48-52 Ford panel truck for years. I found this one on ebay and managed to get it for $355. It was a 1000 mile round trip to get it but I believe it was worth it. The worst damage on the truck is the rear fenders, the driver side had been dented up at some point and the wheel...

Congrats Dennis! Got the latest issue in the mail yesterday. Nice feature, the photos of that thing are nice.

Something along these lines? http://shop.wintecfabrication.com/product.sc?productId=362&categoryId=7

I need to find a brake line routing diagram for a 67 Olds Delmont 88. Specifically from the master cyl. out to the proportioning valve and then out to the 4 corners. Any ideas where to find such a thing? Or maybe someone here has 1 they could check for me? Thanx in advance,Tim G.

*OK it's that time of year again, well a few weeks early but this is one of the better swap meets around. * *South Jersey Region AACA 39th Annual Swap Meet & Car Corral* Over 350 vendor spaces, tailgaters welcome, plenty of parking. Automotive related items only. Held rain, shine or snow....

Using an un_narrowed 9" rear end from '58 Ford truck w/ 4" offset in channeled '31 A. Drive shaft angle (off trans tail shaft and pinion shaft) in Ford truck (w/60" drive shaft) is 3.8 degrees. Drive shaft angle in A is 6.4 degrees (w/ 36" drive shaft). This is side to side, not up & down _which is...

I have a Spirit Industries 23' T bucket frame and I think I want to build a truck instead of a bucket. I would like to use the frame I have for a bobbed rear truck rod. Anyone out there do this before? Its 108" long and 26 1/2'" wide.